Chelsio Communications Chelsio T4 Betriebsanweisung PDF herunterladen (Seite 146)

100

101

Chapter IX. FCoE Full Offload Initiator

i. Following steps will enable FCoE services on a particular VLAN and does a VSAN-VLAN

mapping. Need not do these steps every time, unless a new mapping has to be created.

switch(config)# vlan 2

switch(config-vlan)# fcoe vsan 2

switch(config-vlan)#exit

ii. Following steps help in creating a virtual fibre channel (VFC) and binds that VFC to a

Ethernet interface so that the Ethernet port begins functioning as a FCoE port.

switch(config)# interface vfc 13

switch(config-if)#bind interface ethernet 1/13

switch(config-if)# no shutdown

switch(config-if)#exit

switch(config)#vsan database

switch(config-vsan-db)# vsan 2

switch(config-vsan-db)#vsan 2 interface vfc 13

switch(config-vsan-db)#exit

iii. Assign VLAN ID to the Ethernet port on which FCoE service was enabled in step1.

switch(config)# interface ethernet 1/13

switch(config-if)#switchport mode trunk

switch(config-if)#switchport trunk allowed vlan 2

switch(config-if)#no shutdown

switch(config)#exit

If you are binding the VFC to a MAC address instead of an ethernet port then

make sure the ethernet port is part of both default VLAN and FCoE VLAN.

Note

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 373 374

Kommentare zu diesen Handbüchern

Keine Kommentare

Chelsio Communications Chelsio T4 Betriebsanweisung Seite 146

Kommentare zu diesen Handbüchern