
Chapter VII. iSCSI PDU Offload Target
Chelsio T5/T4 Unified Wire For Linux Page 116
To turn on or off the target to initiator
markers on the connection.
Chelsio only supports “No”.
To set the interval for the initiator to
target markers on a connection.
To set the interval for the target to
initiator markers on a connection.
4.4.3. Chelsio Entity Settings
Description
Chelsio Entity Parameters pass control information to the Chelsio iSCSI module. The
parameters are specific to Chelsio’simplementation of the iSCSI node (target or initiator) and
are unique for each entity block. The parameters consist of information that can be put into
three categories:
1. Challenge Handshake Authentication Protocol (CHAP).
2. Target specific settings. All of the following parameters can have multiple instances in one
target entity block (i.e., they can be declared multiple times for one particular target).
Portal Group
Storage Device
Access Control List (ACL)
Table of Chelsio Entity Settings
Chelsio CHAP Parameter (Target)
CHAP user id and secret for the target.
<user id> must be less than 256
characters. Commas “,” are not
allowed.
<secret> must be between 6 and 255
characters. Commas “,” are not
allowed.
The target user id and secret are used
by the initiator to authenticate the
target while doing mutual chap.
NOTE: The double quotes are required
as part of the format.
CHAP user id and secret for the
initiator.
<user id> must be less than 256
characters. Commas “,” are not
Kommentare zu diesen Handbüchern