Chelsio Communications Chelsio T5 Betriebsanweisung PDF herunterladen (Seite 154)

100

101

Chapter IX. Data Center Bridging (DCB)

Chelsio T5/T4 Unified Wire For Linux Page 154

iv. Enabling DCB:

switch(config)# interface ethernet 1/13

switch(config-if)# priority-flow-control mode auto

switch(config-if)# flowcontrol send off

switch(config-if)# flowcontrol receive off

switch(config-if)# lldp transmit

switch(config-if)# lldp receive

switch(config-if)# no shutdown

v. On the FC Ports, if a FC target is connected then perform the following steps -

switch(config)#vsan database

switch(config-vsan-db)#vsan 2

switch(config-vsan-db)# vsan 2 interface fc 2/2

switch(config-vsan-db)#exit

switch(config)interface fc 2/2

switch(config-if)# switchport mode auto

switch(config-if)# switchport speed auto

switch(config-if)# no shutdown.

vi. If you have not created a zone then make sure the default-zone permits the VSAN created,

otherwise the initiator and the target on that particular VSAN although FLOGI’d into the

switch will not talk to each other. To enable it, execute the below command.

switch(config)# zone default-zone permit vsan 2

4.2. Configuring the Brocade 8000 switch

i. Configure LLDP for FCoE.Example of configuring LLDP for 10-Gigabit Ethernet interface.

switch(config)#protocol lldp

switch(conf-lldp)#advertise dcbx-fcoe-app-tlv

switch(conf-lldp)#advertise dcbx-fcoe-logical-link-tlv

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 459 460

Kommentare zu diesen Handbüchern

Keine Kommentare

Chelsio Communications Chelsio T5 Betriebsanweisung Seite 154

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Chelsio Communications Chelsio T5