Chelsio Communications Chelsio T5 Betriebsanweisung PDF herunterladen (Seite 164)

100

101

Chapter X. FCoE PDU Offload Target

Chelsio T5/T4 Unified Wire For Linux Page 164

3.1.2. Configuring the FCoE ports

In this procedure, you may need to adjust some of the parameters to suit your environment,

such as VLAN IDs, Ethernet interfaces, and virtual Fibre Channel interfaces

i. Following steps will enable FCoE services on a particular vlan and does a vsan-vlan

mapping. Need not do these steps every time, unless a new mapping has to be created.

switch(config)# vlan 2

switch(config-vlan)# fcoe vsan 2

switch(config-vlan)#exit

ii. Following steps help in creating a virtual fibre channel (VFC) and binds that VFC to a

Ethernet interface so that the Ethernet port begins functioning as a FCoE port.

switch(config)# interface vfc 13

switch(config-if)#bind interface ethernet 1/13

switch(config-if)# no shutdown

switch(config-if)#exit

switch(config)#vsan database

switch(config-vsan-db)# vsan 2

switch(config-vsan-db)#vsan 2 interface vfc 13

switch(config-vsan-db)#exit

iii. Assign VLAN ID to the Ethernet port on which FCoE service was enabled in step1.

switch(config)# interface ethernet 1/13

switch(config-if)#switchport mode trunk

switch(config-if)#switchport trunk allowed vlan 2

switch(config-if)#no shutdown

switch(config)#exit

If you are binding the VFC to a MAC address instead of an ethernet port then

make sure the ethernet port is part of both default VLAN and FCoE VLAN.

Note

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 459 460

Kommentare zu diesen Handbüchern

Keine Kommentare

Chelsio Communications Chelsio T5 Betriebsanweisung Seite 164

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Chelsio Communications Chelsio T5